363-206-305 Trouble Clearing:
TAP-113
Issue 3, June 2000 Page 5 of 6
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
24. If a circuit pack(s) is installed in the wrong slot, remove the circuit pack.
Determine correct position of the circuit pack and install circuit pack into the
correct slot.
Check circuit pack switch settings for valid settings or wrong settings
(DLP-513). If switch settings are to be changed from what they were
previously, update the equipment list by momentarily depressing the UPD/INIT
button on the SYSCTL after the circuit pack is reinstalled.
25. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
26.
NOTE:
Indications are that the circuit pack installed in the protection slot is
different from the service circuit packs in a shelf configured for 1X7 low
speed protection.
Determine the Source Address from the Alarm and Status Report.
Refer to the Commands and Reports section of this manual under RTRV-ALM
for a more detailed description of the meaning of the report.
27. If this is acceptable execute the update (upd) command to clear the alarm.
Otherwise, one or more of the low-speed service or protection circuit packs
must be changed.
Check circuit pack switch settings for valid settings or wrong settings
(DLP-513). If switch settings are to be changed from what they were
previously, update the equipment list by momentarily depressing the UPD/INIT
button on the SYSCTL after the circuit pack is reinstalled.
28. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
29. Has the SYSCTL been replaced?
If YES, proceed to Step 34.
If NO, continue with Step 30.
30. Use the CIT and reset command to reset SYSCTL.
31. Is the MN alarm LED still lighted after about 20 to 60 seconds?
If YES, continue with Step 32.
If NO, STOP. YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...