DLP-512
: Detailed Level Procedure 363-206-305
Page 2 of 10 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
set-fecom Enables or disables far end communication
(DCC/LAN) over the data communication channel and
sets Network Side/User Side parameters.
set-lgn Enters, edits, and deletes logins and passwords.
Privileged users can change other users’ passwords
by using this command.
set-link Sets length of page output on the CIT.
set-ne Sets the name [Target Identifier (TID)] of the network
element. Designates a shelf as an alarm gateway
network element (AGNE) and sets alarm group
numbers. Designates the Shelf numbers and
designates the Central Office/Remote Terminal
parameter. Sets the Idle Channel Signal parameter.
set-passwd Sets or changes a users’ password. All users can
change their own passwords.
set-pmthres-line Sets the thresholds of the line performance
parameters. Also enables or disables the processing
of the threshold crossings for these performance
parameters.
set-pmthres-sect Sets the thresholds of the section performance
parameters. Also enables or disables the processing
of the threshold crossings for these performance
parameters.
set-pmthres-t1 Sets the thresholds of the DS1 performance
parameters. Also enables or disables the processing
of the threshold crossings for these performance
parameters.
set-pmthres-t3 Sets the thresholds of the DS3 performance
parameters. Also enables or disables the processing
of the threshold crossings for these performance
parameters.
set-pmthres-sts1 Sets the STS-1 path performance parameter
thresholds. Available only in Release 2 or later
software.
set-pmthres-vt1 Sets the thresholds of the VT1.5 path performance
parameters. Also enables or disables the processing
of the threshold crossings for these performance
parameters.
To Next Page
Loading...