DLP-512
: Detailed Level Procedure 363-206-305
Page 4 of 10 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
set-oc12 Sets the characteristics of an OC-12 line pair. Sets the
signal degrade threshold of the OC-12 line as a bit
error rate (BER). Specifies if sync message signaling
uses kbyte or sbyte or is enabled or disabled.
set-state-oc1 Sets the state of OC-1 line(s) to be monitored (IS) for a
good signal or not monitored (NMON).
set-state-ec1 Sets the state of a low-speed EC-1 port to be
automatically monitored (AUTO) for a good signal or
not monitored (NMON).
set-state-t1 Sets the state of a low-speed port to be automatically
monitored (AUTO) for a good signal or not monitored
(NMON).
set-state-t3 Sets the state of a DS3 port to be automatically
monitored (AUTO) for a good signal or not monitored
(NMON).
set-state-sts1 Sets the state of a STS-1 channel to be automatically
monitored (AUTO) for a good signal or not monitored
(NMON).
set-state-vt1 Sets the state of a VT1.5 channel to be automatically
monitored (AUTO) for a good signal or not monitored
(NMON).
set-sts1 Sets the signal degrade characteristics of an STS-1
channel.
set-t1 Sets the characteristics of a DS1 port.
set-t3 Sets the characteristics of a DS3 port.
set-vt1 Sets the signal degrade characteristics of a VT1.5
channel.
3. Determine options required from office records.
To Next Page
Loading...