Lucent Technologies FiberReach DDM-2000 - Page 1554

DLP-514
: Detailed Level Procedure 363-206-305
Page 2 of 22 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
2. Route the optical jumpers up through the slotted hole(s) at the bottom left-front
corner of the shelf and up to the
OLIU
s. See Table A.
3. Establish communication with technician at other end of the optical span.
4.
NOTE:
The optical connector labeled
OUT
is the output from the
OLIU
. The
optical connector labeled
IN
is the input to the
OLIU
.
NOTE:
26G-U/26G2-U OLIU
s and
27G-U/27G2-U OLIU
s require single-mode
optical fiber; however, multimode cable can be used for short
connections.
22F-U/22F2-U/22G2-U/22G3-U/22G4-U OLIU
s require
single-mode optical fiber; however, multimode cable can be used for
short connections.
22D-U OLIU
s and FT-2000
LAA5 IS3
Optical
Interface require multimode optical fibers.
28G-U/28G2-U OLIU
s and
FT-2000
LAA10/LAA10B OC3
Optical Interface require single-mode
optical fibers; however miltimode cable can be used for short
connections.
29G-U/29H-U OLIU
s and FT-2000
T939A OC12
Optical
Interface require single-mode optical fibers.
28G-U/28G2-U OLIU
s and
Table A – Single-Mode Lightguide Jumpers
Code Comcode
Length
(Feet) Connectors
FS1E-E-2 105357727 2
ST
-
ST
FS1E-E-10 105357768 10
ST
-
ST
FS1E-E-25 105357800 25
ST
-
ST
FS1E-E-50 105357859 50
ST
-
ST
FS1E-E-100 105357875 100
ST
-
ST
FS1E-A-2 105420905 2
ST
-2016A Biconic
FS1E-A-10 105420947 10
ST
-2016A Biconic
FS1E-A-25 105423958 25
ST
-2016A Biconic
FS1E-A-50 105424006 50
ST
-2016A Biconic
FS1E-A-100 105424022 100
ST
-2016A Biconic
LS1SC-SC-2 106908247 2 SC-SC
LS1SC-SC-10 106908270 10 SC-SC
LS1SC-SC-25 106908304 25 SC-SC
LS1SC-SC-50 106908346 50 SC-SC
LS1SC-SC-100 106908395 100 SC-SC
LS1FP-FP-10 106593825 10 FCPC-FCPC
LS1FP-FP-25 106932908 25 FCPC-FCPC
LS1FP-FP-50 106932916 50 FCPC-FCPC
LS1FP-FP-100 106932924 100 FCPC-FCPC