DLP-518
: Detailed Level Procedure 363-206-305
Page 4 of 12 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Figure 4. Sample Report From rtrv-map-neighbor Command (Release 3.1 and
Later)
2. Verify system configuration is same as specified on work order or circuit order.
3. From work order or circuit order, determine the terminating (drop) nodes for
the service being established.
4.
NOTE:
In single ring configurations, cross-connections consist of pass-through
cross-connections in addition to the terminating cross-connections. For
example in Figure 1, if the terminating nodes are at Node 1 and Node 5,
then pass-through cross-connections will have to be made at Nodes 2, 3,
4 and 6.
NOTE:
In ring configurations, you should use the following rules in establishing
cross-connections in each ring:
1. All drop connections (including DRI, if present) from the same
STS-1 timeslot must be provisioned the same, either all VT1.5 or
STS-1.
2. If all 28 VT1.5s (DS1s) in an STS-1 are being passed through at a
node in a VT1.5 path-switched ring, then the cross-connection may
be provisioned as either a pass-through STS-1 or VT1.5.
3. On STS-1 path-switched rings, all nodes in the ring must be provi-
sioned as STS-1 cross-connections.
From work order, circuit order, and the sketch made in
Step 1
, determine the
pass-through nodes for the service being established.
*/
Site6NE1/* Network Map for
Site6NE1 FiberReach
39 840F 80 000000 0000 0000 0000 08006alad06e 00
Site7NE1 main-1
39 840F 80 000000 0000 0000 0000 08006a1ad06f 00
Site5NE1 main-2 ? N
39 840F 80 000000 0000 0000 0000 00000e3a0372 00
TID Connected Thru Product Type Level 2 IS DCC
NSAP
======================================================================
======================================================================
To Next Page
Loading...