Lucent Technologies FiberReach DDM-2000 - Page 1606

DLP-522
: Detailed Level Procedure 363-206-305
Page 2 of 2 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
3. If security has been enabled, enter your login and password when you are
prompted.
If security has not been enabled, enter a carriage RETURN.
Response: System responds with:
4.
NOTE:
After the prompt, the remote system will respond normally to any
commands entered just as if you were physically connected to the remote
terminal.
See the "Commands and Reports" section of this manual for a description of
the commands formats.
5.
NOTE:
A logout entered to the remote terminal will end the remote session and
return control to the near-end CIT. A logout entered to the near-end
terminal will terminate the local and remote sessions.
Use the command logout to log out of the remote terminal session and
return control to the near-end terminal.
6.
STOP. YOU HAVE COMPLETED THIS PROCEDURE.
TID date time
M rtrv-alm: all COMPLD
/* Active Alarms and Status Report
Lucent Technologies
DDM-2000 FiberReach
Release a.b.c
**********************************
**********************************/
/
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
.
.
.