DLP-523
: Detailed Level Procedure 363-206-305
Page 12 of 12 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
34.
NOTE:
If signal has previously been applied to the original
DS3
circuit pack, the
FAULT
LED will flash when the new
DS3
is installed until the signal tests
good.
Remove old
DS3
circuit pack and install replacement
DS3
circuit pack.
Response:
FAULT
LED on the
DS3
circuit pack flashes for about 15
seconds and then goes off
35.
STOP. YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...