363-206-305 Detailed Level Procedure:
DLP-526
Issue 3, June 2000 Page 1 of 18
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Make VT1.5 (DS1) or STS1 Cross-Connections
Using CIT Single/Dual Homing OC3/OC-1
or OC-12/OC1 Ring Configuration
1.
NOTE:
If you are not familiar with doing cross-connections using the CIT
commands, it is strongly suggested that you read
Cross-Connection
Provisioning
in the "Administration and Provisioning" section of this
manual. Also, read the description of the following commands in the
"Commands and Reports" section of this manual and the DDM-2000
OC-3 manual: ent-crs-sts1, ent-crs-vt1, rtrv-crs-sts1,
rtrv-crs-vt1, dlt-crs-sts1, and dlt-crs-vt1.
NOTE:
You will have to log in to more than one node in each ring to get a
complete map of the network using the rtrv-map-network and
rtrv-map-neighbor command. If a drawing of the network is not
provided with the work order, it is recommended that you draw a simple
schematic of the network before making cross-connections.
Make a simple drawing of the network and list the TID of each node and how
they are connected to each other. Figure 1 shows an example of a simple
schematic.
Log in to any node in each ring in the network and use the
rtrv-map-network and/or rtrv-map-neighbor command to retrieve a
map of the network which lists all the systems and how they are connected to
each other.
Sample output reports are shown in Figures 2, 3, and 4.
To Next Page
Loading...