363-206-305 Detailed Level Procedure:
DLP-528
Issue 3, June 2000 Page 1 of 8
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Make VT1.5 (DS1) Cross-Connections Using CIT
Stand Alone OC-1 Ring Configuration
1.
NOTE:
This procedure may also be found in 363-206-285,
DDM-2000 OC-3
Multiplexer, TARP Release 13 and Later, User/Service Manual (TOP) -
Volume II
.
NOTE:
If you are not familiar with doing cross-connections using the CIT
commands, it is strongly suggested that you read
Cross-Connection
Provisioning
in the "Administration and Provisioning" section of this
manual. Also, read the description of the following commands in the
"Commands and Reports" section of this manual: ent-crs-vt1.
NOTE:
You will have to log in to more than one node in each ring to get a
complete map of the network using the rtrv-map-network and
rtrv-map-neighbor command. If a drawing of the network is not
provided with the work order, it is recommended that you draw a simple
schematic of the network before making cross-connections.
Make a simple drawing of the network and list the TID of each node and
how they are connected to each other. Figure 1 shows an example of a
simple schematic.
Log in to any node in the ring and use the rtrv-map-network and/or
rtrv-map-neighbor command to retrieve a map of the network which lists
all the systems and how they are connected to each other. Sample output
reports are shown in Figures 2, 3, and 4.
To Next Page
Loading...