363-206-305 Detailed Level Procedure:
Issue 3, June 2000 Page 1 of 14
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DLP-530
Make Cross-Connections Using CIT
Single Homing/Linear Extensions or Dual Homing
OC-48/OC-3/12 and OC-192/OC-3/12 Ring
Configuration
1.
NOTE:
If you are not familiar with doing cross-connections using the CIT
commands, it is strongly suggested that you read
Cross-Connection
Provisioning
in the "Administration and Provisioning" section of this
manual and the appropriate documentation in the FT-2000 or WaveStar
User/Service Manual. Also, read the description of the following
commands in the "Commands and Reports" section of this manual and
the DDM-2000 FiberReach manual: ent-crs-sts1, ent-crs-vt1 ,
rtrv-crs-sts1, rtrv-crs-vt1, dlt-crs-sts1, and
dlt-crs-vt1.
NOTE:
You will have to login to more than one node in each ring to get a
complete map of the network using the rtrv-map-network and
rtrv-map-neighbor command. If a drawing of the network is not
provided with the work order, it is recommended that you draw a simple
schematic of the network before making cross-connections.
Make a simple drawing of the network and list the TID of each node and how
they are connected to each other. Figures 1 and 8 show examples of simple
schematics.
2. Log into any node in each ring in the network and use the
rtrv-map-network and/or rtrv-map-neighbor command to retrieve a
map of the network which lists all the systems and how they are connected to
each other.
To Next Page
Loading...