DLP-534
: Detailed Level Procedure 363-206-305
Page 4 of 8 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
To do the new generic program installation using floppy diskettes, all the following
files must be on a single diskette:
The remaining files similar to the following can be on the same diskette or on another
diskette:
To do the new generic program installation using the PC hard disk, all the files listed
in the README file must be on the hard disk in the directory from which you will do
the installation.
To read the contents of the README file, use the more < README command. To list
the files on the hard disk or floppy diskette, use the dir/p command.
Copying Files — Hard Disk System
Set up your hard disk so that when you turn on your computer, it starts up using the
hard disk instead of the
MS-DOS
system diskette. When prompt
C:>
appears, type
the following commands:
Insert the original generic program diskette in drive
A
, and close the door. Type the
following command:
copy a:*.* <ENTER>
This command tells
MS-DOS
software to copy all of the files from the
A
drive to the
C
drive (hard disk). Open the drive door, and remove the original diskette from the
drive. Repeat this procedure for all diskettes.
CHECKPGM.EXE CRTM.EXE CTRM.INI CTRM.SCR GENERIC.0
PCLOAD.EXE README TERM.BAT STAGE_1.0 STAGE_10.0
GENERIC.1 GENERIC.2 GENERIC.3 GENERIC.4 GENERIC.5 ...
GENERICO.0 GENERICO.1 GENERICO.2 ...
mkdir ngp <ENTER>
cd ngp <ENTER>
To Next Page
Loading...