363-206-305 Detailed Level Procedure:
DLP-535
Issue 3, June 2000 Page 7 of 16
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Figure 7. Sample Report From rtrv-map-neighbor Command (Release 3.1 and
Later)
2. Verify system configuration is same as specified on work order or circuit order.
For example, see Figures 8 through 13.
3.
NOTE:
Cross-connections consist of drop and pass-through connections. For
example in Figures 8 and 9, drop connections are made at Nodes 1, 4,
and 5 or 4, 5, and 7. Pass-through cross-connections are made at other
nodes in the network (Figures 3 and 4). Also, cross-connections must be
made in all interconnected rings, including other FiberReach, DDM-2000
OC-3 rings, DDM-2000 OC-12 rings, FT-2000 OC-48, and WaveStar
TDM OC-48/192 rings, as required. See
ent-crs-( )
command in the
Commands and Reports section of Volume 1 of this manual.
From work order or circuit order, determine the terminating (drop) nodes for
the service being established.
4. From work order, circuit order, and the sketch made in Step 1, determine the
pass-through nodes for the service being established.
5. From work order or circuit order, determine the host OC-12 node(s) that
connects to the FiberReach OC-3 ring(s).
*/
Site6NE1/* Network Map for
Site6NE1 FiberReach
39 840F 80 000000 0000 0000 0000 08006alad06e 00
Site7NE1 main-1
39 840F 80 000000 0000 0000 0000 08006a1ad06f 00
Site5NE1 main-2 ? N
39 840F 80 000000 0000 0000 0000 00000e3a0372 00
TID Connected Thru Product Type Level 2 IS DCC
NSAP
======================================================================
======================================================================
To Next Page
Loading...