363-206-305 Detailed Level Procedures:
DLP-541
Issue 3, June 2000 Page 3 of 4
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
8.
NOTE:
The checkpgm command may take up to 25 minutes to complete.
Execute the checkpgm command to check the version number of the program
you are installing. If using floppy disks, insert each diskette when prompted.
Response: PC has DDM-2000 program version a.b.c.
9.
NOTE:
The cable from the front CIT port on the DDM-2000 must be connected to
the COM (COM1 or COM2) RS-232 port of the PC.
Connect PC to CIT port by connecting one end of an RS-232 cable to the
COM( ) port of the PC and the other end of the cable to the front DDM-2000
CIT port.
10. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
approx. 15 min. if using hard drive
approx. 25 min. if using floppy drive
To Next Page
Loading...