363-206-305
Issue 3, June 2000 Page 3 of 8
DDM-2000 F
IBER
R
EACH
N
ARROWBAND
S
HELF
9. If you need assistance in clearing a trouble after completing all the applicable
trouble-clearing procedures in this section, contact your local or regional
maintenance assistance group. The telephone number for the Lucent Technologies
Regional Technical Assistance Center (RTAC) is
1-800-225-RTAC
.
Circuit packs being returned for repair should be sent to the following address:
Lucent Technologies
Returned Goods Dept.
7725 West Reno Avenue
Oklahoma City, OK 73126-0060
Screen Display and Panel Stamping Fonts
The procedures in this manual use a monospace font to identify actual text on a screen or a
response displayed from the system. A
bold
font identifies panel stamping such as alarm
names or circuit pack names. Also, the
bold
font is used throughout this manual for
emphasis.
DDM-2000 FiberReach Installation
363-206-310,
DDM-2000 FiberReach Multiplexer Installation Manual
, is available for
customers planning to install the equipment themselves. To acquire this manual, refer to
"How to Order Documents" in the
About This Document
tab.
Lucent Technologies recommends that ONLY designated Lucent Technologies cables be
used with DDM-2000 FiberReach. Failure to use these cables will void the product
warranty.
To Next Page
Loading...