TAP-102
: Trouble Clearing 363-206-305
Page 2 of 2 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
N
ARROWBAND
S
HELF
8. Has the replacement unit that was installed in
Step
6
been replaced while
performing this trouble procedure?
9. Press
LED TEST
button on
DSXBIU
.
Requirement: All
LEDs light on
DSXBIU
and all other circuit packs.
If all LEDs do not light, replace the
DSXBIU
.
10. Remove your wrist strap, secure the electronics compartment.
11.
STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If
YES
, escalate to next level of support.
If
NO
, replace unit by repeating this procedure starting at
Step 5
.
To Next Page
Loading...