Lucent Technologies FiberReach DDM-2000 User Manual

363-206-305
Operations Interfaces
Issue 3 June 2000
6-7
CPro Graphical User Interface and Provisioning
Tool
6
The CPro Graphical User Interface and Provisioning Tool is a
Microsoft
*
Windows
based user interface that can optionally be used with the DDM-2000 FiberReach
Multiplexer. The tool simplifies and mechanizes administration, maintenance, and
provisioning operations. With the tool a user can:
■
Display and control cross-connections at each NE in a ring and the entire
ring
■
Obtain and display graphical images of the ring configuration, equipment,
and cross-connections
■
Perform an analysis of the ring to detect provisioning errors
■
Retrieve and store data about a selected NE
■
Back up and restore all provisioning information.
In response to a user, the tool automatically compiles and sends all the necessary
commands to perform a task. If the user is provisioning cross-connections, for
example, the tool automatically prevents provisioning errors by comparing the new
provisioning information with the ring inventory. For more information, see the on-
line documentation provided with the tool or 365-576-160 (
CPro-2000 User
Manual
, Release 10.0.) See Chapter 10, "Technical Specifications," for PC
requirements to use the tool.
* Microsoft is a registered trademark of Microsoft Corporation.

Lucent Technologies FiberReach DDM-2000 Specifications

General

Brand	Lucent Technologies
Model	FiberReach DDM-2000
Category	Multiplexer
Language	English