Lucent Technologies FiberReach DDM-2000 - Page 363

363-206-305
Administration and Provisioning
Issue 3 June 2000
8-5
The following commands are restricted to privileged users over the CIT and DCC
interfaces.
■
init-sys
— Initialize System
■
rstr-passwd
— Restore login and password file
■
rtrv-lgn
— Retrieve Login
■
rtrv-passwd
— Retrieve login and password file
■
set-feat
— Set Features
■
set-fecom
— Set Far-End Communications
■
set-lgn
— Set Login
■
set-secu
— Set Security
■
set-sync
— Set Synchronization characteristics.
When security is enabled (default is “disable”), the following additional commands
become restricted to privileged users only:
■
apply
— Locally Overwrite Executing Software
■
cpy-prog
— Copy Program
■
dlt-osacmap
— Delete OS application context ID map
■
ent-osacmap
— Enter OS application context ID map
■
ent-tl1msgmap
— Enter TL1 message map for OS
■
ent-ulsdcc-l3
— Enter Upper Layer Section DCC - Layer 3
■
ent-ulsdcc-l4
— Enter Upper Layer Section DCC - Layer 4
■
dlt-ulsdcc-l4
— Delete Upper Layer Section DCC - Layer 4
■
init-pm
— Initialize Performance Monitoring
■
ins-prog
— Install Program
■
reset
— System Reset
■
set-date
— Set network element (NE) Date and time
■
set-ne
— Set NE name.
■
set-x25
— Set X.25 baud rate for OS.
Reports-only users can execute the following commands:
?
(help),
logout
,
rlgn
,
set-passwd
(their own),
toggle
, and all
rtrv
commands
except
,
rtrv-lgn
,
and
rtrv-passwd
.
For details on these and other commands, see Chapter 11, "Commands and
Reports."