363-206-305
Maintenance Description
9-38
Issue 3 June 2000
parameter are provisionable, via the CIT, on a per shelf basis. Therefore, if values
other than the defaults are to be used, only one value needs to be set for each
parameter. Generation of TCAs can be disabled independently for each
performance parameter. Performance data is still collected if thresholding is
disabled. Refer to the
rtrv-pmthres-line
,
rtrv-pmthres-sect
,
rtrv-
pmthres-sts1
,
set-pmthres-line
,
set-pmthres-sect
,
set-pmthres-
sts1
,
rtrv-pm-tca
,
rtrv-pmthres-vt1
,
rtrv-pmthres-t1
,
rtrv-pmthres-t3
,
set-pmthres-vt1
,
set-pmthres-vt3
and
set-
pmthres-t1
commands in Chapter 11, "Commands and Reports."
Threshold Crossings Reported to OS
9
To trigger proactive maintenance activity at the OS, threshold crossing alerts
(TCAs) are reported via TL1
REPT-EVT
autonomous messages.
Reports
9
This section provides information in reports available through the CIT. For reports
available via the TL1 interface, refer to 824-102-151, DDM-
2000 Multiplexers
Operations Systems Engineering Guide
.
Alarms and Status Report
9
The system provides a report that lists all active alarm and status conditions. The
identity of the condition (circuit pack failure, incoming signal failure, etc.) is
included in the report along with a time stamp indicating when the condition was
detected.
See the
rtrv-alm
command in Chapter 11, "Commands and Reports," for a
complete list of the alarm and status conditions that are reported by the system.
Provisioning Reports
9
Provisioning reports list the current state of all provisionable options in the system.
See the
rtrv-attr-alm
,
rtrv-attr-cont
,
rtrv-attr-env
,
rtrv-crs-vt1
,
rtrv-crs-sts1
,
rtrv-crs-sts3c,
rtrv-fecom
,
rtrv-lgn
,
rtrv-link
,
rtrv-ne
,
rtrv-oc1
,
rtrv-oc3
,
rtrv-pmthres-line
,
rtrv-pmthres-sect
,
rtrv-pmthres-sts1
,
rtrv-pmthres-t1
,
rtrv-pmthres-vt1
,
rtrv-secu
,
rtrv-state-equip
,
rtrv-state-path
,
rtrv-state-sts1
,
rtrv-sts1
,
rtrv-sync
,
rtrv-t1
,
rtrv-t3, rtrv-trace-sts1, rtrv-ulsdcc-l3,
rtrv-ulsdcc-l4
,
rtrv-state-vt1
and
rtrv-vt1
commands in Chapter 11,
"Commands and Reports."
To Next Page
Loading...
Need help?
General
