363-206-305
Maintenance Description
9-40
Issue 3 June 2000
monitored. This report also includes the protection switching state ("active" or
"standby") and protection switching priority of all protected lines and equipment in
the system. See the
rtrv-state
-
(t1, sts1, vt1)
command in Chapter 11,
"Commands and Reports."
Path State Report
9
This report lists each VT1.5 active and standby path in a path switched ring
configuration. The active paths are identified and the protection switching status of
each path is provided. See the
rtrv-state-(t1,sts1,vt1)
command in
Chapter 11, "Commands and Reports."
Equipment Report
9
This report displays the equipage and version information for one or more slots.
Refer to the
rtrv-eqpt
command in Chapter 11, "Commands and Reports."
Network Map Reports
9
The network report lists the TIDs and NSAPs of all reachable NEs (including level
2 ISs) in the local area only, or all reachable level 2 IS NEs in the subnetwork (if
the local NE is provisioned to be a level 2 IS). Refer to the
rtrv-map-network
command in Section 11, "Commands and Reports."
To Next Page
Loading...