Lucent Technologies FiberReach DDM-2000 - Page 635

INIT-SYS 6of1Page INIT-SYS
NAME
SystemInitializeinit-sys:
FORMATINPUT
init-sys: Address ;
DESCRIPTION
!
CAUTION:
commandTheservice.affectmaycommandthisofExecution
init-sys:all Thissystem.in-serviceanonusedbeNOTshould
systembeforeinstallationofendtheatusedbeonlyshouldcommand
turnup.
Thevalues.defaulttheirtoparametersprovisionableinitializescommandThis
end.farthefromresetareparametersdateandtime
NOTE:
theenteringAfter init-sys transientshowwillsystemthecommand,
aisThisreports.HistoryandAlarmtheinrecordedarethatfailuresDCC
response.systemexpectednormal,
commandThe init-sys:all installationofendtheatonlyusedbeshould
commandTheturnup.systembefore init-sys:sysctl usedbeonlyshould
theproblem,systemaclearToreplaced.isSYSCTLaafter reset command
thechangingwithoutsoftwaresystemtheresetsitsinceused,beshould
inparameterpagetheforexceptparametersprovisioned set-link iswhich,
case.thisinvaluedefaulttoreset
NOTE:
only.usersprivilegedtoavailableiscommandThis
is:parameterinputThe
Address areparameterscontrollersystemjustwhetherdeterminesAddress
allwhetherorinitialized aresystementiretheonparameters
values:followingthehavemayAddressinitialized.
sysctl addressThe sysctl systemaafterusedbecan
theisItsystem.in-serviceanonreplacediscontroller
10withinbuttonUPD/INITthepressingofequivalent
CRthe(whilesequencestart-upprocessortheofseconds
restorescommandThisflashing).ispanelusertheonLED
values:defaulttheirtoparametersoflistfollowingthe
FiberReachDDM-2000 2000June3Issue 11-75