363-206-305
System Introduction
Issue 3 June 2000
1-9
■
ITM SNC Release 5.0 enhancements for FiberReach Release 3.0:
— ITM SNC software download to FiberReach
*
— ITM SNC as the TL1 GNE
— ITN SNC backup and restore enhancements.
■
Default TID. The default Target Identifier (TID) for R 3.0 is LT-DDM-2000,
instead of the previous default of Site#NE#.
■
TL1 commands:
— RTRV-CID-SECU (also new CIT command RTRV-SECU) to report
the active user logins.
— RTRV-LOG to report the 500 most recent events in the history log
(equivalent to existing CIT command RTRV-HSTY).
— ENT-FECOM to provision DCC user-side/network-side settings and
to enable or disable remote access via each DCC (equivalent to
existing CIT command SET-FECOM which is now supported via CIT
remote login and OS).
— RTRV-FECOM to report the provisioned state of each DCC
(equivalent to existing CIT command RTRV-FECOM).
Release 3.1 (TARP Release)
supports the following features:
■
Supports the OC-3 optics through the 28G-U/28G2-U OLIU circuit packs in
the Main Unit slots and therefore supports all the related features that were
added to Release 2.2. The related OC-3 features are as follows:
— STS-1 pass-through cross-connections on the 28G-U/28G2-U
equipped FiberReach shelves
— Full OC-3 VT cross-connections to Main slots equipped with the
28G-U/28G2-U OLIU
— Provisionable S1 byte option, if the FiberReach shelf is equipped
with the OC-3 interfaces in both Main Unit slots
— Provisionable
Synch Autoconfiguration.
■
Supports the STS-3c 0X1 application using the OC-3 interface (22-type) in
the Function Unit slots of the FiberReach NEs.
■
Supports the DS3 (BBG4B Circuit Pack) in the Function Unit slots of the
FiberReach shelf. This provides the ability of transporting STS-1 services
using the DS-3 circuit packs in the Function Unit slots.
* This feature will be useful when upgrading from FiberReach Release 3.0 to later releases.
To Next Page
Loading...