Lucent Technologies FiberReach DDM-2000 - Page 893

SET-SYNC 5of2Page SET-SYNC
are:parametersinputThe
mdsw values:followingtheofonehavemayModeSwitching
revertive value).(defaultswitchingmodeRevertive
toduemodetimingholdovertoswitchessystemtheIf
automaticallywillitreferences,timingtheoffailurea
modetimingprovisionedthetobackswitch
(LineTimed becomesreferencestheofoneafter)
good.
nonrevertive switching.modeNonrevertive
toduemodetimingholdovertoswitchessystemtheIf
willitreferences,timingtheoffailurea not
timingprovisionedthetobackswitchautomatically
(mode LineTimed becomesreferencetheafter)
Thegood. switch-sync usedbemustcommand
modetimingprovisionedthetosystemtherestoreto
(LineTimed).
src shelfwhichfromlinetheselectsparameterThisSynchronizationSource.
followingtheofonehavemayparameterThisderived.bewilltimingline
values:
main-1 (default)
main-2
auto releases.laterand3.1FiberReachwithavailableisparameterThis
timingbestthechoosetosystemtheallowsSyncAutoreconfiguration
TheTiming.Lineforprovisionedisitwhenusetosource
synchronizationtheonbasedisselectionsourcesynchronization
sources.(synchronization)timingavailablethefromreceivedmessages
sourcetimingstandbythetoplacetakesSwitchingProtectionAutomatic
willthereandnonrevertive,isswitchThefails.sourceactivethewhen
reference.timingformerthetobackswitchautomaticanbenot
automaticallysystemtheenabled,isSyncAutoreconfigurationWhen
with(startingFiberReachForsources.timinglinebetweenreconfigures
4.0)and3.1Release main-1 and main-2 (ifoptionssourcetheare
unitMaininOLIUs29-typeor28-type26,withequippedisshelfthe
slots).
NOTE:
OLIUs,26-typewithequippedisshelftheWhen auto is enabled
OLIUs,28/29-typewithequippedisshelftheWhendefault.by
auto is disabled default.by
theUse switch-sync timingotherthetoswitchmanuallytocommand
source.
FiberReachDDM-2000 2000June3Issue 11-333