120
SC100/200 Series Users Manual EM-6337-B Rev.15
Appx 6. REVISION HISTORY
CHANGES FROM VERSION 1.3 TO 1.40
1. PC Congurator Cable available for conguration.
2. Function Block List “Model No. 58: Segment Linearizer” function was modied.
3. Function Block List “Model No. 64 Moving Average” function was modied.
4. High-speed pulse Pi6 can be used as Discrete input Di6.
CHANGES FROM VERSION 1.4 TO 1.5
1. TAG name, FN1 to FN4, can be displayed. (Maximum 4 characters)
2. Engineering unit value can be set in User’s parameter table
3. Function Block List (EM-6460-B) “Model No. 17: rate-of-change limit” function was added.
4. Yellow bar on the right side blinks during program mode.
5. Error Status shows history log.
6. Function Block List (EM-6460-B): Error of RUN contact can be reset manually.
7. Backup starts, if 5 seconds after supplying power, the connection with main unit is not established.
To Previous Page
Loading...
Need help?
General
