75
SC100/200 Series Users Manual EM-6337-B Rev.15
6.3.5.2. USER’S PARAMETER TABLE VIEW OPERATIONS
Home button
Used to switch the view to the one registered as Home operation view.
Eng button
Used to switch among the engineering views.
Pressing/holding the button for approx. 1 second switches the view to Operation view.
Page UP button
Used to go to the previous page.
Page DOWN button
Used to go to the next page.
Parameter
Touching over a parameter cell switches the view to the Parameter Setting View for the row.
Range value
Touching over a Range cell opens a numeric keypad.
The numeric keypad is not available (1) when ‘ ******* ’ is indicated in Range cell for which illegal GROUP and/or ITEM No.
are set, or (2) when the Cong. mode is set to ‘SFEW.’
Note
Calculation errors when converting range value to internal percentage.
When 20000 and 0 is set as Range high/low limit, setting to 9999 and converting to percentage, 49.995 % is obtained,
however, internally it is processed as 49.99 %. Therefore the display shows “9998”.
Only the acceleration button among the hardware buttons at the front is usable when the Realtime I/O Monitoring view is
on screen. The MV value UP/DOWN buttons and the AUTO / MAN selector are locked.
Home Button
Eng Button
Page UP Button
Page DOWN Button
Parameter
Range value
To Next Page
Loading...