M-system SC100 - 6.3.5. USER’S PARAMETER TABLE VIEW

74
SC100/200 Series Users Manual EM-6337-B Rev.15
6.3.5. USER’S PARAMETER TABLE VIEW
6.3.5.1. SCREEN COMPONENTS
Alarm Indicator
Red bar blinks during error.
Operation Buttons
Parameter Column
Parameter type specied
in the parameter setting
view.
Page
Range Column
Present Range value
for the specied
GROUP and ITEM type
Engineering Unit Column
Unit specied in the
parameter setting view.
PRG mode indicator
Yellow bar blinks during program mode
1.50
• At the maximum of 40 parameters (10 per page, 4 pages in total) can be registered for the user’s convenience.
• Parameters are registered in the Parameter Setting View.
• Only the parameter type identication is displayed when it is disabled in the Parameter Setting view.
• ‘ ******* ’ is indicated in Range cell when illegal GROUP and/or ITEM No. are set for the parameter.