M-system SC100 - 7. FUNCTION BLOCK SETTING

81
SC100/200 Series Users Manual EM-6337-B Rev.15
7. FUNCTION BLOCK SETTING
The Controller functions are programmable combining various function blocks.
Although most basic functions of PID control are already set at the factory, the Controller can provide advanced functions by
conguring internal function blocks with Loop Conguration Builder software (model: SFEW3E).
Function blocks are common to all devices in M-System’s MsysNet system.
7. 1. GENERAL DESCRIPTION
• Only One Software for All Devices
Every module in the MsysNet system utilizes one common software, except for the Field Terminal specically used for each
of them. If you learn how to congure one module, you will understand all others.
• No Computer Language: Software Function Blocks
The MsysNet system does not use any specialized computer language, but the “Software Function Blocks”. It incorporates
programming concepts for PID controllers, computation modules or PLCs which are familiar to users.
• User-Friendly Parameter Setting Software
Loop Conguration Builder software for the SC100/200 Series (model: SFEW3E) is available. With the builder software, you
can build conguration les, copy them, save them, and print them.