M-system SC100 - Users Parameter Table; Screen Components

52
SC100/200 Series Users Manual EM-6337-B Rev.15
6.2.5. USER’S PARAMETER TABLE
1.50
6.2.5.1. SCREEN COMPONENTS
Parameters are registered in the Parameter setting view displayed from User’s parameter table in the Engineering views.
Refer to 6.3.5.3. PARAMETER SETTING VIEW OPERATIONS.
Page
Parameter Column
Parameter type specied in
the parameter setting view.
Range Column
Present Range value for the
specied GROUP and ITEM
type.
Engineering Unit Column
Unit specied in the
parameter setting view.
• At the maximum of 40 parameters (10 per page, 4 pages in total) can be registered for the user’s convenience.
• Only the parameter type identication is displayed when it is disabled in the Parameter Setting view.
• ‘ ******* ’ is indicated in Range cell when illegal GROUP and/or ITEM No. are set for the parameter.
Operation Buttons
Alarm Indicator
Red bar blinks during error.
PRG mode indicator
Yellow bar blinks during program mode
1.50