215922 254 Revision A
Knife/Disc Drive Hydraulics
A single piston hydraulic pump works in a closed-loop circuit providing oil to the knife/disc circuit. The pump will maintain
knife/disc speed at all normal operating engine speeds (>1500 rpm), regardless of varying loads on the header.
The pump requires charge flow in order to:
• Replace oil from internal leakages
• Fill and maintain positive pressure in the work circuit
• Provide flushing flow for cooling, and introduce clean oil into the circuit.
Reel and Draper Hydraulics
The reel and draper circuits are powered by a gear pump. This allows independent oil flow to the reel and draper circuit
and separates oil flow from the knife pump. The header drive manifold manages flow control and relief for these circuits.
Traction Drive Hydraulics
The windrower traction drive consists of two variable displacement axial piston hydraulic pumps, one for each drive wheel.
The pump’s speeds are increased through a gearbox from the engine. Each pump requires charge flow in order to
• Replace oil from internal leakages
• Fill and maintain positive pressure in the work circuit
• Provide flushing flow for cooling (occurs at the motors), and introduce clean oil into the circuit.
MAINTENANCE AND SERVICING
To Next Page
Loading...
