215922 76 Revision A
Reel Position Four-Way Switch
The reel position four-way switch on the ground speed lever (GSL) performs different functions depending on the attached
options.
Figure 3.61: Ground Speed Lever
A - Reel Down B - Reel Forward
C - Reel Up D - Reel Aft
For specific operating instructions, refer to the following
sections:
• Reel fore-aft position and height on draper headers:
– 4.7.2 Adjusting Reel Fore-Aft Position, page 203
– 4.7.3 Adjusting Reel Height, page 204
• Center-link assist cylinder:
– 4.5.1 D1X or D1XL Series Draper Header, page 166
• Double Windrow Attachment (DWA) position:
– 4.6.6 Double Windrowing, page 198
Reel and Disc Speed Switch
The reel and disc speed switch on the Ground Speed Lever (GSL) adjusts the reel or disc speed, depending on the type of
header attached to the windrower. The switch can also operate the turn signals on the windrower when the header is not
in use.
Figure 3.62: GSL Reel and Disc Speed Switch
• Press and hold + button (A) to increase the reel or
disc speed.
• Press and hold – button (B) to decrease the reel or
disc speed.
• Release the button when the reel or disc is at the desired
speed.
For instructions, refer to the applicable header topic for
detailed use of these switches.
NOTE:
The REEL and DISC SPEED switch can operate the turn signals
when the header is not in use. For example, when driving in the
engine-forward position, or when operating in the cab-forward
position with the header disengaged.
NOTE:
The reel and auger speeds are hydraulically linked on the A40DX Auger Header. When the reel speed is changed, the auger
speed changes automatically. Independent reel and auger adjustment is available on the A40DX GSS (Grass Seed) using the
differential auger-reel control feature. It is also available on the A40DX (not Grass Seed) as an option: the Reel Speed
Control kit (MD #B6604).
IMPORTANT:
The reel speed on an A40DX Auger Header MUST NOT EXCEED 85 rpm. The auger speed MUST NOT EXCEED 320 rpm.
OPERATOR’S STATION
To Next Page
Loading...
