MacDon M1170NT5 - Towing Header with Windrower

215922 154 Revision A
1034118
A
B
Figure 4.75: Transport Electrical Connector
21. Disconnect the narrow transport electrical harness from
connector (B) and return it to holder (A).
Towing Header with Windrower
The windrower can be used to tow a MacDon draper header that has the Slow Speed Transport option installed.
IMPORTANT:
Ensure the optional weight box is installed on the windrower to transfer weight to the lift arms. For instructions, refer to
Preparing Windrower to Tow a Header, page 155.
1020166
Figure 4.76: Towing a Header
WARNING
• A windrower without a header or weight box must NOT be
used to tow headers due to reduced traction and possible
loss of control.
• For towed equipment without brakes, do NOT exceed
32 km/h (20 mph).
CAUTION
• To tow a header with an M1170NT5 Windrower, the header
must be equipped with the appropriate equipment to
comply with local regulations.
• Before towing, verify that the signal lighting and safety
equipment is installed and functioning properly.
• Do NOT exceed the combined gross vehicle weight (CGVW) specified in Table 4.3, page 155.
• To prevent damage and/or loss of control, ensure the machine and attached equipment are within the following
weight limits:
OPERATION