EasyManua.ls Logo

MacDon M1170NT5 - Page 41

MacDon M1170NT5
504 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
215922 21 Revision A
1000701
Figure 1.36: MD #166463
MD #166463
Collision hazard
DANGER
To prevent injury or death from a collision between the
windrower and other vehicles when driving the windrower on
public roadways:
Obey all highway traffic regulations in your area. Use pilot
vehicles in the front and the rear of the windrower (if
required by law).
Use a slow-moving vehicle emblem and activate the
machines warning lights, unless these actions are prohibited
by law.
If the width of the attached header impedes other vehicle
traffic, remove the header and install a MacDon approved
weight box onto the windrower. Refer to the windrower and
header operators manuals for instructions on safely towing
the header.
Adjust the drive wheel width and walking beam width for
road transportation as required per local regulations
(narrow transport option only available on some models).
For instructions, refer to the operators manual for safe
procedure.
1014917
Figure 1.37: MD #166824
MD #166824
Hot fluid spray hazard and fluid fill rate information
CAUTION
Hydraulic fluid is under pressure, and can be extremely hot. To
prevent injury:
Do NOT remove the fluid fill cap when the engine is hot.
Allow the engine to cool down before opening the fluid
fill cap.
Fill the tank slowly. Do NOT exceed a fill rate of 11 L/min
(3 gpm).
SAFETY

Table of Contents

Related product manuals