6-22
[5] OFF TIMER
Adjust the Auto shut-OFF time of the Transmitter power.
1. Shift the cursor (
or ) using the Hook raising and lowering
lever and select the preferred time.
The Auto shut-OFF adjust is by 3 steps, 5 min., 10 min., or
15min.
The factory setting for this function is “5 minutes”.
2. When the desired time is obtained, push the Hook stow/Setting
button. The time in above 1. will be fixed and the display returns
to the A MODE screen.
[6] LOW IDLING UP
CAUTION
The low idling rate regulated by this idling-up function is valid only during crane operation
levers are manipulated. Once the lever is released, the low idling rate is reset to the normal rate.
Adjust the engine‘s low idling rate to higher than the normal rate,
during the crane operation levers are manipulated.
1. Shift the cursor ( or ) using the Hook raising and lowering
lever. When all the bars light, the idling up is in the maximum,
otherwise, when the all are OFF, the idling up is canceled.
2. When the suitable idling up rate is obtained, push the Hook
stow/Setting button. The value obtained in above 1. will be fixed
and the display returns to the A MODE screen.
[7] MICRO SPEED MODE RESET
Select either to reset or preserve the value at the micro speed
mode.
1. Shift the cursor (
or ) using the Hook raising and lowering
lever and select “N” or “Y”.
To reset, select “Y”, otherwise, select N” to preserve.
2. Whether reset or not is fixed, push the Hook stow/Setting button.
The status in above 1. will be fixed and the display returns to the
A MODE screen.
[8] VERSION INFORMATION
Push the Hook stow/Setting button, so that version information
of the Transmitter firmware is displayed. Another push of the
same button makes the display returns to the A MODE screen.
To Next Page
