Magnetek IMPULSE G+ 4 Series User Manual

IMPULSE
®
•G+ & VG+ Series 4 Technical Manual
November 2020
Page 115
5.2.26 Inch Control
The Inch Control function can be enabled by programming H01-01–08 = 17, 18, and 19, respectively. The
frequency reference used during inching is determined by B01-17 (Jog Reference).
Table 5-42: Inch Control Parameter Settings
Figure 5-16: Inching Function and Inching Repeat
Parameter Display Function Range Default
C13-01 Inch Run Time Inching Control run time 0.00–2.55 sec 1.00
C13-02 Repeat Delay Tim Inching Control repeat delay time 0.00–2.55 sec 1.00
CAUTION
A directional input is not needed to enable motor torque.

Magnetek IMPULSE G+ 4 Series Specifications

General

Brand	Magnetek
Model	IMPULSE G+ 4 Series
Category	DC Drives
Language	English