IMPULSE
®
•G+ & VG+ Series 4 Technical Manual
November 2020
Page 78
5.1.13 Accel/Decel Time Switching Frequency
Accel/Decel times can be changed automatically without using multi-function inputs. When multi-function digital
inputs are set for Accel/Decel selection, this command has priority over automatic change of Accel/Decel.
Table 5-11: Accel/Decel Time Switching Frequency Parameter Settings
* Range is extended to 0.0–6000.00 when B05-16 = 1.
Parameter Display Function Range Default
B05-05 Acc Time N Chg Sets Acceleration time at Acc/Dec Switch
Frequency (B05-10)
0.0–25.5 sec 2.0
B05-06 Dec Time N Chg Sets Deceleration time at Acc/Dec Switch
Frequency (B05-10)
0.0–25.5 sec 2.0
B05-08 Fast Stop Time Sets deceleration time for complete stop at
external fault. See Section 5.6.5 on page 157.
0.0–25.5 sec 0.5
B05-10 Acc/Dec SW Freq Determines acceleration/deceleration time
settings
0.0–E01-04 0.0
B05-11 SW Freq. Compare Determines when Acceleration Time and
Deceleration Time at Speed Switch Hz is
enabled:
0, 1 1
0 Lower SW Freq 0: B05-05/B05-06 enabled, U01-02 < B05-10
1 Upper SW Freq 1: B05-05/B05-06 enabled, U01-02 > B05-10
B05-12 Accel Time 3 Acceleration time 3 enabled when H01-xx = 1B. 0.0–25.5 sec* 3.0
B05-13 Decel Time 3 Deceleration time 3 enabled when H01-xx = 1B. 0.0–25.5 sec* 3.0
B05-14 Accel Time 4 Acceleration time 4 enabled when H01-xx = 1C. 0.0–25.5 sec* 3.0
B05-15 Decel Time 4 Deceleration time 4 enabled when H01-xx = 1C. 0.0–25.5 sec* 3.0
B05-16 Acc/Dec Ext Rang Enables extended range of Acc/Dec Params:
B05-01–B05-04, B05-12–B05-15, C03-02,
C03-03, C03-05 and C03-06
0, 1 0
0 Disabled Range = 0.0–25.5
1 Enabled Range = 0.0–6000.0
To Next Page
Loading...
Need help?
General
