Magnetek IMPULSE G+ 4 Series User Manual

IMPULSE
®
•G+ & VG+ Series 4 Technical Manual
November 2020
Page 136
5.4.3 Test Mode Configuration
Test Mode is a troubleshooting aid that is intended for troubleshooting Flux Vector control method problems. This
feature cannot be left on indefinitely, as it will generate a fault after being on for a total accumulated time of ten
minutes. At this time, the fault must be reset or the power must be cycled.
To enable Test Mode, refer to parameter L05-01.
Table 5-61: Test Mode Configuration Parameter Settings
Parameter Display Function Range Default
E03-01 Control Method Control Method 0, 2 2
0 V/f Control
2 Open Loop Vector
E03-02 Stopping Method Deceleration Method 0, 1 1
0 Decel to Stop
1 Coast to Stop
E03-03 Max Frequency Maximum Frequency 40.0–150.0 Hz 60.0
E03-04 Max Voltage Maximum Voltage 230 V: 0.0–255.0
460 V: 0.0–510.0
575 V: 0.0–733.1
Determined by
O02-04
E03-05 Base Frequency Motor Base Frequency 0.0–150.0 Hz 60.0
E03-06 Mid Frequency A Motor Middle output frequency 0.0–150.0 Hz Determined by
E01-03
E03-07 Mid Voltage A Motor Middle output frequency voltage 230 V: 0.0–255.0
460 V: 0.0–510.0
575 V: 0.0–733.1
Determined by
E01-03
E03-08 Min Frequency Minimum Frequency 0.0–150.0 Hz Determined by
E01-03
E03-09 Min Voltage Motor Minimum output frequency voltage 230 V: 0.0–255.0
460 V: 0.0–510.0
575 V: 0.0–733.1
Determined by
E01-03
E03-10 Mid Frequency B Midpoint Output Frequency B 0.0–150.0 Hz 0.0
E03-11 Mid Voltage B Midpoint Output Voltage B 230 V: 0.0–255.0
460 V: 0.0–510.0
575 V: 0.0–733.1
0.0
E03-12 Base Voltage Motor Base Voltage 230 V: 0.0–255.0
460 V: 0.0–510.0
575 V: 0.0–733.1
0.0

Magnetek IMPULSE G+ 4 Series Specifications

General

Brand	Magnetek
Model	IMPULSE G+ 4 Series
Category	DC Drives
Language	English