Magnetek IMPULSE G+ 4 Series User Manual

IMPULSE
®
•G+ & VG+ Series 4 Technical Manual
November 2020
Page 164
NOTE: After initial communication, if the VFD is not communicated with for 2 seconds, a communication fault will
occur (CE alarm/fault).
H05-11 Enter CommandSel 0, 1 1
0 Enter Required VFD requires an Enter command before
accepting any changes to parameter
settings.
1 No EnterRequired Parameter changes are activated
immediately without the Enter command.
H05-12 Run CommandSel 0, 1 0
0 FWD Run &REV Run
1 Run & FWD/REV
H05-17 Busy Enter Sel Allows VFD to substitute a RAM enter with
a ROM enter when under heavy CPU load.
0, 1 0
0 No ROM Enter
1 RAM Enter
H05-18 MtrSpd Monitor T Motor Speed Monitor Filter Time. Allows
adding a filter to the Motor Speed monitor
(U01-05).
0–100 ms 0
Parameter Display Function Range Default

Magnetek IMPULSE G+ 4 Series Specifications

General

Brand	Magnetek
Model	IMPULSE G+ 4 Series
Category	DC Drives
Language	English