Group Function
Monitor
U01 Monitor
U02 Fault Trace
U03 Fault History
U04 Maintenance
U06 Control Monitor
Initialize
A01 Initialization Parameters
A02 User-Defined Parameters
Application
B01 Speed References
B02 Reference Limits
B03 Run/Reference Source
B05 Acceleration/Deceleration
B08 Jump Frequencies
Special
Function
C01 Quick Stop
C01 Reverse Plug Simulation
C02 Micro-Speed
C03 End of Travel Limits
C03 Phantom Stop
C03 Load Sharing/Torque Following
C03 Klixon
C03 Hook Height Measurement
C03 Electronic Programmable Limit Switches (EPLS)
C04 Load Float
C05 Load Check II
C06 Swift-Lift/Ultra-Lift
C07 Torque Limit
C07 Anti-Shock
C08 No-Load Brake Hoist
C08 Brake Answerback
C09 Digital Input (DI-A3, S4I, or S4IO) Option Card Setup
C10 Weight Measurement
C11 Slack Cable Detection
C11 Snap Shaft Detection
C12 Delay Timers and Timer Functions
C12 Inch Control
C13 Index Control
Tuning
D01 DC Injection Braking
D02 Motor Slip Compensation
D03 Torque Compensation
D04 Automatic Speed Regulator Tuning
D05 Torque Control
D08 Dwell
D09 S-Curve Acceleration/Deceleration
D10 Carrier Frequency
D11 Hunting Prevention
Motor
E01 V/f Pattern
E02 Motor Setup
E03 Test Mode Configuration
Options
F01 Encoder Feedback (PG-X3) Option Card Setup
F02 Analog Input (AI-A3) Option Card Setup
F04 Analog Output (AO-A3) Option Card Setup
F05 Digital Output (DO-A3 or S4IO) Option Card Setup
F06 Profibus-DP (SI-P3) Option Card Setup
F07 Ethernet (SI-EN3) & Modbus (SI-EM3) Option Card Setup
Termin al
H01 Digital Inputs
H02 Digital Outputs
H03 Analog Inputs
H04 Analog Outputs
H05 Serial Communication Setup
H06 Pulse Train Input/Output Setup
Protection
L01 Motor Overload
L02 Power Loss Ride Thru
L03 Stall Prevention
L04 Reference Detection
L05 Test Mode
L06 Torque Detection
L08 Hardware Protection
L09 Automatic Fault Reset
L09 Fault Latch
Keypad
O01 Monitor Selection
O02 Keypad Key Selection
O03 Maintenance History
O04 Copy Function
B09 Field Forcing
C08 Emergency Lift
To Next Page
Loading...
Need help?
General
