12. Connect the green and blue power tilt wires to the tilt relays. Cover the connections with the red boots.
a - Blue (up) tilt relay terminal and wire
b - Green (down) tilt relay terminal and wire
13. Secure the wires to the electrical bracket with a cable tie.
Starboard Bracket Removal
1.
Remove the power tilt lower pivot screw and washer.
2. Remove the screw securing the ground cable.
3. Remove the port tilt tube cap.
4. Loosen the locknut.
5. Push the tilt tube towards the starboard side to allow the starboard nut to be removed.
6. Remove the tilt tube cap and nut.
7. Remove the starboard clamp bracket.
a - Ground cable screw
b - Nut
c - Cap
d - Lower pivot pin screw (M8 x 20) and washer
e - Tilt lock pin, locknut, and washer
Clamp/Swivel Bracket and Driveshaft Housing
Page 5A-28 © 2018 Mercury Marine 90-8M0125265 eng NOVEMBER 2017
To Next Page
Loading...
Need help?
General