EasyManuals Logo

Mercury 20 EFI FourStroke Service Manual

Mercury 20 EFI FourStroke
406 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #371 background imageLoading...
Page #371 background image
5. Insert the lanyard stop switch through the tiller handle housing and secure it from below with a plastic nut. Tighten the nut
to the specified torque.
a - Lanyard stop switch
b - Nut
Description Nm lb‑in. lb‑ft
Plastic nut 2.0 17.7 –
6. Apply 2‑4‑C with PTFE to the shift cable input rod and eyelet.
Tube Ref No. Description Where Used Part No.
95
2-4-C with PTFE Shift cable input rod and eyelet 92-802859A 1
7. Place the shift cable in the retaining slot, and attach the shift cable to the shift handle with a locknut.
8.
Thread new cable ties in the cable tie mounts.
9. Install the throttle handle:
a. Position the throttle cable pulley housing.
b. Install the friction clamp on the throttle handle shaft.
c. Slide the throttle handle partially over the end of the tiller handle chassis.
a
b
63441
Tiller Handle
Page 7B-14 © 2018 Mercury Marine 90-8M0125265 eng NOVEMBER 2017

Table of Contents

Other manuals for Mercury 20 EFI FourStroke

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 20 EFI FourStroke and is the answer not in the manual?

Mercury 20 EFI FourStroke Specifications

General IconGeneral
BrandMercury
Model20 EFI FourStroke
CategoryEngine
LanguageEnglish

Related product manuals