5.1 Unpacking and Packing
All P634 devices are packaged separately into dedicated cartons and shipped
with outer packaging. Use special care when opening cartons and unpacking
devices, and do not use force. In addition, make sure to remove supporting
documents and the type identification label supplied with each individual device
from the inside carton. The design revision level of each module included in the
device when shipped can be determined from the list of components (assembly
list). This list of components should be filed carefully.
After unpacking, each device should be inspected visually to confirm it is in
proper mechanical condition.
If the P634 needs to be shipped, both inner and outer packaging must be used. If
the original packaging is no longer available, make sure that packaging conforms
to DIN ISO 2248 specifications for a drop height ≤ 0.8 m.
5 Installation and Connection P634
P634/EN M/R-42-A // P634‑311‑653 5-3
To Next Page
Loading...
