Micom P634 - Communication Interface 2 (Function Group COMM2)

3.4.3 Communication Interface 2 (Function Group COMM2)
Communication interface 2 supports the IEC 60870‑5‑103 interface protocol.
In order for data transfer to function properly, several settings must be made in
the P634.
64Z5189A
Commun. interface
1
0
COMM2:
General enable USER
[ 103 170 ]
0: No
1: Yes
1
0
COMM2:
Sig./meas.block.USER
[ 103 076 ]
0: No
1: Yes
1
0
COMM2:
Command block. USER
[ 103 172 ]
0: No
1: Yes
MAIN:
Prot. ext. disabled
[ 038 046 ]
MAIN:
Test mode
[ 037 071 ]
COMM2:
Line idle state
[ 103 165 ]
COMM2:
Baud rate
[ 103 071 ]
COMM2:
Parity bit
[ 103 171 ]
COMM2:
Dead time monitoring
[ 103 176 ]
COMM2:
Mon. time polling
[ 103 202 ]
COMM2:
Octet comm. address
[ 103 072 ]
COMM2:
Name of manufacturer
[ 103 161]
COMM2:
Octet address ASDU
[ 103 073 ]
COMM2:
Spontan. sig. enable
[ 103 177 ]
COMM2:
Select. spontan.sig.
[ 103 179 ]
COMM2:
Transm.enab.cycl.dat
[ 103 074 ]
COMM2:
Cycl. data ILS tel.
[ 103 175 ]
COMM2:
Delta V
[ 103 050 ]
COMM2:
Delta I
[ 103 051 ]
COMM2:
Delta f
[ 103 052 ]
COMM2:
Delta meas.v.ILS tel
[ 103 150 ]
COMM2:
Delta t
[ 103 053 ]
Fig. 3-14: Settings for communication interface 2.
3 Operation
P634
P634/EN M/R-42-A // P634‑311‑653 3-19