6.8.1 Configuration of the Function Keys F1 to Fx
Function keys [F1] to [Fx] can be assigned a password (see Section 6.11.9, (p. 6-
31)). In such a case they are effective only after that password has been
entered. By default, no password is required to use the function key.
It is assumed for the following operating example that function key [F1] is
enabled only after the password (as assigned at F_KEY: Password funct.key
1) has been entered. After the password has been entered the function key will
remain active for the duration set at F_KEY: Return time fct.keys.
Thereafter, the function key is disabled until the password is entered again.
6 Local Control (HMI) P634
P634/EN M/R-42-A // P634‑311‑653 6-11
To Next Page
Loading...
