Micom P634 - List Parameters

6.11.5 List Parameters
6.11.5.1 Setting a List Parameter
Using list settings, the user is able to select several elements from a list in order
to perform tasks such as defining a trip command or defining the measurements
that will be displayed on Measured Value Panels. As a rule, the selected elements
are linked by an “OR” operator. Other operators (NOT, OR, AND, NOT OR and
NOT AND) are available in the LOGIC function group for linking the selected list
items. In this way binary signals and binary input signals can be processed in a
Boolean equation tailored to meet user requirements. For the DNP 3.0
communication protocol, the user defines the class of a setting instead of
assigning operators. The definition of a trip command shall be used here as an
illustration.
P634 6 Local Control (HMI)
6-22 P634/EN M/R-42-A // P634‑311‑653