7.1.2 Configuration Parameters
Parameter Address
Default Min Max Unit Logic Diagram
Local control panel
LOC: Language
003 020
2: Reference language
[spacer]
Language in which texts will be displayed on the user interface (HMI).
[spacer]
LOC: Decimal delimiter
003 021
1: Dot
[spacer]
Character to be used as decimal delimiter on the local control panel.
[spacer]
LOC: Password
003 035
1234 0 4444
[spacer]
The password to be used for changing settings from the local control panel can
be defined here.
[spacer]
LOC: Fct. reset key
005 251
060 000: MAIN: Without function Fig. 3-66, (p. 3-97)
[spacer]
Selection of counters and memories that are reset by pressing the RESET key on
the local control panel. (Resetting LED indicators and measured event values is
permanently assigned internally, so that they are always reset when the RESET
key is pressed.)
[spacer]
LOC: Fct. read key
080 110
060 000: MAIN: Without function
[spacer]
Selection of up to 16 functions to be triggered when pressing the read key.
Event counters and event recordings are offered for selection. If several
functions have been selected then they will be sequentially triggered by
repeated pressing of the read key.
[spacer]
LOC: Fct. menu jmp list 1
030 238
060 000: MAIN: Without function
[spacer]
LOC: Fct. menu jmp list 2
030 239
060 000: MAIN: Without function
[spacer]
Selection of specified functions which will be sequentially displayed by repeated
reading of the menu jump list 1 (or 2).
[spacer]
LOC: Fct. Operation Panel
053 007
060 000: MAIN: Without function Fig. 3-2, (p. 3-5)
[spacer]
Definition of the values to be displayed on the Measured Value Panel also
referred to as the Operation Panel.
[spacer]
LOC: Fct. Overload Panel
053 005
060 000: MAIN: Without function Fig. 3-4, (p. 3-7)
[spacer]
Definition of the values to be displayed on the Overload Panel.
P634 7 Settings
7-12 P634/EN M/R-42-A // P634‑311‑653
To Next Page
Loading...
