Version Changes
COMM1,
COMM2
The menu points (003 161) COMM1: Name of
manufacturer and (103 161) COMM2: Name of
manufacturer can no longer be set by using a
selection list but, for reasons of compatibility, they may
now be defined as free text. The default is SE but, in
individual cases, it may become necessary to enter
texts differing from the default.
Notes:
●
These parameters can only be set using the
operating program and it is not possible to set
them locally using the integrated local control
panel (HMI). The maximum text length is 8
characters and designations exceeding this will
be truncated.
●
The parameter COMM1: Name of
manufacturer is hidden unless an IEC 60870-5
protocol is enabled.
LED, MAIN, ... The English designation texts of the following data
points have been changed, but their functionality
remains unchanged. The old designation is shown on
the left and the new designation on the right-hand side.
LED: Fct. assig. H12 rot → LED: Fct.assig. H12
red
SFMON: Unsuff. no. of ends → SFMON: Unsuff.
No. of ends
CBF_4: CB pos. implausibel → CBF_4: CB pos.
implausible
MAIN: Disconnect End A EXT → MAIN:
Disconnect end a EXT
MAIN: End A disconnected → MAIN: End a
disconnected
MAIN: Disconnect End B EXT → MAIN:
Disconnect end b EXT
MAIN: End B disconnected → MAIN: End b
disconnected
MAIN: Disconnect End C EXT → MAIN:
Disconnect end c EXT
MAIN: End C disconnected → MAIN: End c
disconnected
MAIN: Disconnect End D EXT → MAIN:
Disconnect end d EXT
MAIN: End D disconnected → MAIN: End d
disconnected
P634 A5 P634 Version History
A5-24 P634/EN M/R-42-A // P634‑311‑653
To Next Page
Loading...
