When a device on the network is malfunctioning or application programs are not well
designed or properly configured, broadcast storms may occur that will degrade network
performance and even cause a complete halt. The network can be protected from broadcast
storms by setting a threshold for broadcast traffic for each port. Any broadcast packets
exceeding the specified threshold will then be dropped.
Three options of frame traffic are provided to allow users to enable or disable the storm
control.
Unknown Unicast Rate: Set storm control as the Unknown Unicast Rate.
Multicast Rate: Set storm control as the Multicast Rate.
Broadcast Rate: Set storm control as the Broadcast Rate.
4.4.9 DSCP Remark
To set up DSCP Remark, select the option DSCP Remark from the Switch Management
menu and then the following screen page appears.
Configure DSCP Remark:
Select “DSCP Remark” from the pull-down menu of Select Setting.
To Next Page
Loading...
