Microsens MS400870M Series - User Command Mode

33
FTP or TFTP server.
<username>: Enter the username for
Firmware upgrade via FTP. If you use
TFTP server to upgrade Firmware, you
do not need to specify username.
<password>: Enter the password for
Firmware upgrade via FTP. If you use
TFTP server to upgrade Firmware, you
do not need to specify password.
<filelocation>: Enter the file location
within the FTP or TFTP server.
config <ftp|tftp> <serverip>
<username> <password>
<filelocation>
To restore configuration via FTP or TFTP
server.
<serverip>: Enter the IP address of the
FTP or TFTP server.
<username>: Enter the username for
Firmware upgrade via FTP. If you use
TFTP server to upgrade Firmware, you
do not need to specify username.
<password>: Enter the password for
Firmware upgrade via FTP. If you use
TFTP server to upgrade Firmware, you
do not need to specify password.
<filelocation>: Enter the file location
within the FTP or TFTP server.
2.5.10 User command mode
Command
Parameter
Description
Console(user)#
add <username> [password]
<administrator | read_and_write |
read_only | access_denied>
Add a new user and specify its access
privilege.
<administrator | read_and_write | read_only
| access_denied>: Four operation privileges
are available in the Managed Switch.
Administrator: Full access right includes
maintaining user account & system
information, loading factory settings, etc.
Read & Write: Full access right but cannot
modify user account & system information
and load factory settings.
Read Only: Allow to view only.
Access Denied: Completely forbidden for
access.
For example:
Console(user)#add user1 user1
administrator
delete <username>
Delete a registered user.
For example:
Console(user)#delete user1
Console(user-
radius)#
mode <enable | disable>
To enable or disable RADIUS
Authentication.