Microsens MS400870M Series User Manual

14
2.2 Remote Console Management - Telnet
You can manage the Managed Switch via Telnet session. However, you must first assign a
unique IP address to the Switch before doing so. Use the Local Console to login the
Managed Switch and assign the IP address for the first time.
Follow these steps to manage the Managed Switch through Telnet session:
Step 1. Use Local Console to assign an IP address of the Managed Switch,
 IP address
 Subnet Mask
 Default gateway IP address, if required
Step 2. Run Telnet.
Step 3. Log into the Switch CLI mode.
Limitations: When using Telnet, keep the following in mind:
Only two active Telnet sessions can access the Managed Switch at the same time.

Microsens MS400870M Series Specifications

General

Brand	Microsens
Model	MS400870M Series
Category	Switch
Language	English