Microsens MS400870M Series - Multicast Command Mode

49
<port_list> 1~24
<unlimited | dhcp | fix-ip>:
Unlimited: Non-Limited (Static IP or DHCP
assigns IP).
Fixed IP: Only Static IP (Create Static IP table
first).
DHCP: DHCP server assigns IP address.
For example:
Console(config-ska)#sourceguard 1-4,10-
15,18,19 dhcp
Console(config-ska-
snooping)#
mode <enable | disable>
To enable or disable snooping.
initiated <number>
To specify time that packets might be received.
<number>: 0~9999 Seconds
For example:
Console(config-ska-snooping)#initiated 4
leased <number>
To specify expired time of packets.
<number>: 180-259200 Second
For example:
Console(config-ska-snooping)#leased 86400
Console(config-ska)#
isolation <enable | disable>
If port isolation is set to enable, the customer port
(port 1~24) can‟t communicate to each other.
ipv6-filter <enable | disable>
To enable or disable ipv6 filter.
upnp-filter <enable | disable>
To enable or disable upnp filter.
Console(config-ska-
static-ip)#
add <ip> <mask> <vlan_ip>
<port>
Add a static IP.
<vlan_ip>: 1~4094
<port>: 1~24
delete <ip> <mask>
<vlan_ip> <port>
Delete a static IP.
<vlan_ip>: 1~4094
<port>: 1~24
2.6.13 Multicast command mode
Prompt
Command & Parameter
Description
Console(config-
multicast)#
add <ip-addr> <vlan_id> <port>
To add and configure a new static multicast.
<ip-addr>: 224.0.1.0~238.255.255.255
<vlan_id>: 1~4094
<port>: 1~26
For example:
Console(config-multicast)# add 224.0.1.0
4094 24
delete <ip-addr> <vlan_id>
<port>
To delete a registered static multicast.
<ip-addr>: 224.0.1.0~238.255.255.255
<vlan_id>: 1~4094
<port>: 1~26