Click “Edit” to edit or update the value of each field.
MA Name: View-only field that shows the MA Name of the selected MD.
MEP ID: Specify a MEP ID.
Direction: View-only field that shows the current Maintenance Point direction.
Port: Select a bridge port of the Maintenance Point.
Admin State: To enable or disable Admin State.
CCM State: To enable or disable CCM State.
CCM/LTM Priority: To configure the CCM/LTM priority from the pull-down menu.
Lowest Priority: To configure the lowest priority from the pull-down menu.
Fault Alarm Time: Specify the Fault Alarm Time.
Fault Reset Time: Specify the Fault Reset Time.
To Next Page
Loading...
